Antennas-direct ROTR100 Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Kommunikationszubehör Antennas-direct ROTR100 herunter. Antennas Direct ROTR100 User Manual Benutzerhandbuch

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 8
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 0
HDTV ROTATOR
MODEL ROTR100
INSTALLATION GUIDE
ONE-CABLE OFF-AIR ANTENNA ROTATOR AND CONTROLLER
MADE IN CHINA
ROTR100 INCLUDED PARTS:
(1) DRIVE UNIT
(1) CONTROL UNIT
(1) REMOTE CONTROL
(2 AA BATTERIES INCLUDED)
SPECIFICATIONS
Rotation Time 60 seconds (max) for 360 deg
Total Rotation 450 deg (1.25 rotations)
Motor Voltage +18VDC
Motor Current 350 mA (max)
Mechanical Torque 120 inch-lbs
Return Accuracy 2 deg
Position Sensor Hall sensor
Signaling Format DiSEqC 1.2
Pre-amplifier Power +17VDC at 50mA (max) when used (See notes, Page 6)
Attenuation - Drive Unit 1dB (max) 54-806MHz
Attenuation - Control Unit 1dB (max) 54-806MHz
Input Power 120VAC, 20W
Coax Cable Length 200' (max) RG-6 solid copper center conductor (with no pre-amplifier),
150’ (max) as above, but with an 80mA pre-amplifier (See notes, Page 6),
75’ (max) RG-6 copper covered steel (with no pre-amplifier)
Remote Control Codes Compatible with many Universal Controllers
(See Remote Control Commands, Page 8)
The above specifications are typical and subject to normal manufacturing and service tolerances. These specifications are subject to change without notice.
INSTALLATION GUIDE
VERIFYING ROTATOR OPERATION AND PREPARING FOR INSTALLATION
It is most convenient to make yourself familiar with the operation of the rotator from the comfort of
your living room, rather than after installation.
"
Unpack the Drive Unit, the Controller and the Handheld Remote Control .
"
Install batteries in the Remote Control.
"
Connect a short piece of coaxial cable form the controller’s “ROTATOR” jack to the drive unit’s
“FROM CONTROLLER” JACK.
"
Plug the controller into a 120VAC power source.
"
Switch the unit on.
"
Set the unit to 000 degrees by performing a “RESYNCHRONIZATION” as outlined in that section.
"
Ensure that the North mark on the body is aligned with the arrow on rotating shaft (+/- 3 deg).
"
Make yourself familiar with the available functions - see Remote Control Commands (Page 7).
"
Return the unit to 000 degrees in preparation for installation.
NOTE: Before proceeding to roof, see Rotator Drive Units Assembly, Page 2.
1
ROTR-100 INSTALLATION GUIDE
DRIVE UNIT CONTROL UNIT REMOTE
NOTE: Length of antenna boom may not exceed 131”
Aspen
Eagle
®
TM
Pro Brand
International, Inc.
Seitenansicht 0
1 2 3 4 5 6 7 8

Inhaltsverzeichnis

Seite 1 - Pro Brand

HDTV ROTATOR MODEL ROTR100INSTALLATION GUIDEONE-CABLE OFF-AIR ANTENNA ROTATOR AND CONTROLLERMADE IN CHINAROTR100 INCLUDED PARTS:(1) DRIVE UNIT(1) CONT

Seite 2 - Contents QTY

ROTATOR DRIVE UNIT ASSEMBLY AND INSTALLATION" Ensure the controller is set to 000 degrees (North). Ensure that the drive unit's arrow and No

Seite 3 - COAX CABLE CONNECTIONS

COAX CABLE CONNECTIONSPrior to making these connections, unplug the rotator controller and receiving equipment from 120 VAC power source. Install rub

Seite 4 - INSTALLING THE CONTROLLER

FROM CONTROLLERUSE 2 CABLE BOOTSTO ANTENNARG6 COAXMAIN DOWNLEADROTATORINPUTROTATOR RECEIVERBACK OF CONTROLLERFIG 4:SINGLE COAX CABLE INSTALLATION WITH

Seite 5 - OPERATING THE SYSTEM

OPERATING THE SYSTEMPOWERING THE SYSTEM" Plug the control unit in to the 120 VAC power source. This puts the unit into OFF/STANDBY mode. Note t

Seite 6 - ROTR-100 INSTALLATION GUIDE

DELETING A SINGLE STORED LOCATION"For example to delete stored location “07”, press “DELETE; 07; DELETE”."The display will then count dow

Seite 7 - USING A UNIVERSAL REMOTE

REMOTE CONTROL COMMANDS:(xx = 01 to 99)Store a memory location: STORE xx STOREMove to a memory location: RECALL xx or: UP / DOWNMove to an ang

Seite 8

ONE YEAR LIMITED WARRANTY Pro Brand International, Inc. (PBI) warrants this Eagle Aspen product against any defects in materials or workmanship withi

Kommentare zu diesen Handbüchern

Keine Kommentare