Antennas-direct ClearStream 2 VHF Bedienungsanleitung PDF herunterladen

Quick Start Assembly/Installation Instructions

CLEARSTREAM 2

™

COMPLETE

Before attaching the antenna to any surface, TEST RECEPTION in that area.

Connect the antenna to the TV or receiver and run a full channel scan.

If reception is not as desired, move the antenna and rescan TV/receiver.

Before beginning assembly, make sure all pieces needed are present.

8.5”

14”

Knowledgeable Tech Support

Technical Assistance is available Monday - Friday, 9am - 9pm Central Time

and Saturday - Sunday, 10am - 6pm.

©Antennas Direct 2011 05/11 C2-J30-V

Outdoor Roof Mount

Tools Required: Adjustable Wrench, Power Drill, 3/16” Drill Bit,

8 and 10mm Ratcheting Drivers’ Medium-sized Cross Point Screwdriver.

Thread coaxial cable with the

weather boot (9) through

reflector then through hole in

loop element base (1) and

connect cable to connector on

back of loop element (3).

Secure reflector, base and

screw

together with 3 ½” bolt (6).

Install antenna on mast (4) by

positioning clamp onto mast.

Install wing nuts but do not tighten

them completely.

When reception is as desired, tighten

wing nuts to secure antenna to the mast.

Connect opposite end of

coaxial cable to your TV or

receiver. Point antenna in

direction of your TV stations’

transmission towers, and check

reception by scanning for

channels. If reception is not as

desired move antenna and

rescan.

Mark mast base position on

your surface. Drill a 3/16” hole,

1½ inches deep for each

mounting bolt (7). Place roof

sealing pads (11) then tighten

bolts to secure base to your

surface.

Place the J-mount end cap on

the end of the mount.

Attach J-mount

to mount base

with Hex bolts

Raise dipole

And click into place.

Raise dipole

And click into place.

Leave cables

twist-tied to reflector

1) Reflector with

Loop Element Base

and Collapsable

Dipole

2) 30 ft. Coax Cable

3) Loop Element

4) J-mount Mast

5) Hex Bolts

6) 3 ½” Bolt

7) ¼” x 50mm

Mounting Bolts

8) Mount Base

9) Weather Boot

10) J-Mount Mast

End Cap

11) Roof Sealing Pads

Inhaltsverzeichnis

Seite 1

Quick Start Assembly/Installation InstructionsCLEARSTREAM 2™COMPLETEBefore attaching the antenna to any surface, TEST RECEPTION in that area.Connect t

Kommentare zu diesen Handbüchern

Keine Kommentare

Antennas-direct ClearStream 2 VHF Bedienungsanleitung

Stöbern Sie online oder laden Sie Bedienungsanleitung nach Kommunikationszubehör Antennas-direct ClearStream 2 VHF herunter. Antennas Direct ClearStream 2 VHF User Manual Benutzerhandbuch

Inhaltsverzeichnis

Kommentare zu diesen Handbüchern